Menu
A+ A A-
LDCBS1X2 passive GPS splitter

1x4 Passive GPS Splitter

One input, four output device based on the Wilkinson splitter design

Manufacturer:

Description

Overview

LDCBS1X4 One Input, Four Output Passive GPS Splitter

The LDCBS1X4 GPS Splitter is a one input, two output device based on the Wilkinson splitter design. The frequency response covers the GPS L1 & L2 bands with excellent gain flatness.  In the normal configuration, one of the splitter RF outputs (J1) passes DC from the connected GPS receiver through the splitter to the antenna. The other RF outputs (J2, J3, and J4) are DC loaded with a 200Ω resistor to simulate antenna current draw for receivers on those ports.

Features

  • Excellent Gain Flatness
    |J1 – J4| < 1.0dB
  • Extremely Flat Group Delay 
    Less than 1ns variation
  • Low Insertion Loss
  • Passes all GNSS Frequencies (Entire L-band)
  • DC Blocked Outputs Feature 200Ω Loads 
    Prevent antenna alarm faults from connected devices
  • Phase Matched Outputs 
    Phase (J1 – J4) < 1.0o
  • Special Configurations Available By Request
  • Downloads

    File Type Description
    LDCBS1X4-Spec-Sheet-2015.pdf Spec Sheet LDCBC1X4 Passive GPS Splitter Spec Sheet

    Ordering Info

    Please refer to page 3 of the datasheet: LDCBS1X4-Spec-Sheet-2015.pdf

    By Email

    By Phone

    Main: 604.814.5069
    Fax: 888.831.5149

    By Mail

    Tri-M Technologies Inc.
    208 – 31510 Gill Avenue
    Mission, BC, Canada  V4S 0A1

    Login or Register