Menu
A+ A A-

1x2 Passive GPS Splitter

One input, two output device based on the Wilkinson splitter design

Description

 

Overview

LDCBS1X2 One Input, Two Output Passive GPS Splitter

The LDCBS1X2 GPS Splitter is a one input, two output device based on the Wilkinson splitter design. The frequency response covers the GPS L1 & L2 bands with excellent gain flatness. In the normal configuration, one of the splitter RF outputs (J1) passes DC from the connected GPS receiver through the splitter to the antenna. The other RF output (J2) is DC loaded with a 200Ω resistor to block the DC voltage and to simulate the antenna current draw to prevent false antenna fault detection.

Features

  • Excellent Gain Flatness
    |J1 – J2| < 1.0dB
  • Extremely Flat Group Delay 
    Less than 1ns variation
  • Low Insertion Loss
  • Passes all GNSS Frequencies (Entire L-band)
  • DC Blocked Outputs Feature 200Ω Loads 
    Prevent antenna alarm faults from connected devices
  • Phase Matched Outputs 
    Phase (J1 – J2) < 1.0o
  • Special Configurations Available By Request

    • Downloads

    File Type Description
    LDCBS1X2-SpecSheet-2015.pdf Spec Sheet LDCBC1X2 Passive GPS Splitter Spec Sheet

    Ordering Info

    Please refer to page 3 of the datasheet: LDCBS1X2-SpecSheet-2015.pdf

     

    By Email

    Sales: sales@tri-m.com

    By Phone

    Main: 604.814.5069
    Fax: 888.831.5149

    By Mail

    Tri-M Technologies Inc.
    208 – 31510 Gill Avenue
    Mission, BC, Canada  V4S 0A1

    Login or Register